2012 Toyota Tacoma Step Nerf Bar 6 Cyl 4.0L Go Rhino

I get a new truck every 2 years or so, and have put similar Go Rhino steps on each of my last 5 trucks. They are as advertised. They perform well, and I have never had a problem with these, or any of the others. Installation is simple and it took me about 30 minutes on each side. You remove bolts and then put them back in with the steps attached. I see no reason to buy the really expensive ones, when these do quite nicely - and look good too. Keep them clean, put a coat of wax on every 6-10 months and they should last a long time. I will put them on my next ruck too.

Good product

Ordered these for my 2015 Ram Crew Cab and fit perfectly. Install was straight forward and took about an hour. Directions were clear and makes a big difference in the look of the truck.

DO NOT, I REPEAT DO NOT BUY THIS FOR A QUAD CAB RAM TRUCK!! AutoPartsWAY said this fit my truck (a quad cab) when it in fact does not. It is for a CREW CAB TRUCK, NOT QUAD CAB!! No complaint on the seller as it arrived the day after I ordered it. The mounts fit but the bracketry and such didn't make any sense. There were no directions but you can download them. Since no parts are actually marked for left and right, it is left for you to figure that one out. There were green bags in the packaging so perhaps that is how they are identified. No directions to explain that. The box is marked for 09-10 trucks and not 2015 which I suspect is a non-factor other than having to drill into the truck. If you have a crew cab, this will likely work for you, order away.

I really like these steps and installation was easier than I anticipated!

Ordered item with expedited shipping from AutoPartsWAY. Arrived quickly, but without any mounting hardware as described and expected.AutoPartsWAY said they won't help me in the matter and to contact the manufacturer to obtain replacement parts. Manufacturer seemed helpful until I mentioned I purchased from AutoPartsWAY at which point they refused to assist. AutoPartsWAY replaced order after 3 weeks; the new steps arrived with mounting brackets, but the brackets didn't fit the steps. AutoPartsWAY finally got it right on the third try (several weeks after initial order) and shipped the product with brackets that matched it and my 2012 Chevrolet 2500HD 4x4 Gasoline (extended cab).The steps themselves look great. Installation was straight-forward. BEWARE: Hardware to mount brackets to truck are SAE and hardware to mount brackets to steps are METRIC; the fasteners appear the same, but are very different. The installed product seems sturdy. Installation took ~30 mins by myself.On...

Gave 4 stars cause I was missing a mounting bracket. Not a huge deal, everything else was there. Looks good on my 2006 KingRanch F250. Fit and finish is great.

These are a great buy. I put them on my 2014 dodge crew cab with the 5' 7" bed, they fit and look great. I was able to mount them and still use my rubber mud guards on the front tires.Delivery was quick and they were packaged well to prevent damage.They were not hard to install, however if they would put the bracket part numbers on the directions it would be fool proof.

The steps look amazing. Installation was simple and the shipping was fast.

I had been searching for a quality side step for my 2012 Duramax and finally stumbled across this piece. In my opinion the single piece side steps look much cleaner than the modular pieces.Installation - Easy : Even if you're a novice shade tree mechanic these steps will be a breeze to install. If you carefully read the instructions on the method to install the brackets you will save yourself some time trying to get things perfect. If you have the DEF tank still on the truck it's fairly easy to get the bolt up in the rocker support. No DEF Tank? Super simple on the passenger side.Fit - Good : The brackets all lined up and with a second eye on the lineup you'll get them looking perfect.Quality - Okay : The finish on the steps is great. The step pieces themselves are wonderful as you won't slip with a muddy boot. However, I wasn't very pleased with the finish quality of the third step (bed access step). The last piece wasn't fabricated very...

Great steps. Easy install! Would buy another set if I had to. Definitely recommend these steps to others looking for a quality product

Looks great and priced right. Only issue I have is my driver side bar rattles like crazy. Im always under my truck tightening, loosening and retightening the fastners. Its a real PITA!

Received the steps in great shape. Took about 15-20 minutes a side to install. All parts were included. Great product. Made getting in and out of a Ford F150 with a 4" lift a lot easier than before they were installed.

NOTE : installation on my 2007 Dodge Ram 1500 DID require drilling.Installation was very straight forward: measure the correct distance for the bolt holes on the body's pinch mold. Drill 6 3/8" holes per side. Thread bolts through bracket and mount stepsides. Overall, install took just over an hour with help from a buddy.Make sure you read the instructions! Only on my 3rd time looking over them did I notice that the distance for the bolt holes were marked on the diagram in a very faint grey font.The steps look great and are very sturdy. The step itself is a flat, gnarled surface; no slipping issues or sliding off when stepping on it with wet shoes.Other reviewers have stated theirs came damaged, however mine were not. They arrived in a giant oversized box, and I'm sure that they could get dinged up from moving around. I guess I was lucky.Overall, I'm extremely happy with these stepsides.

Nice product. Looks good and installed fairly easily. Already getting compliments from it. I was worried that it and the chrome bumper wouldn't match but they do fine.

Packaging was a little crazy but it came undamaged. Product looks great on my '04 F150 FX4 super crew. It took about 1 1/2 hrs to install. If you are installing by yourself I suggest installing all the brackets first. Then I used 2 large c-clamps to hold in place while I bolted it, easy. Again, looks great.

Fit great very easy to install has a great look took about 30 min to install I would recommend this to everybody

This item was deivered in 2 days. It was exactly what my husband had wanted and I was so relieved when it came in early!

We ended up returning these for a couple reasons. First of all they were just thrown in a box and were rattling together during shipping. Box was completely mangled and contents were damaged. Second and more importantly they were not as pictured... My fault for not reading the fine print, but the picture does not represent what I received. I'm sure they would have worked fine for somebody, but they wouldn't work for me. I ended up having to pay to return them, which was also awesome. AutoPartsWAY refunded me 10$ for my shipping fee- gee thanks.

I looked at a few different companies and decided to go with Go Rhino. The Dominator II appears to be made well, but falls short on the finish. I purchased mine in a black finish. Out of the box the paint was chipped. This is the leading cause of nerf bar rust issues. The paint chips and the rust starts. A year down the road and the bar are done. I took mine to Line-X and had them sprayed and rust proofed. In conclusion, Bars good, Finish bad.

These are OK bars - just for show. They are body mounted and will not take a full-impact shot like a true frame mounted nerf bar would. A little spendy for what you get. They do look good, though.