Engine Water Pump Bolt Cooling Parts


Showing 1 - 10 of 126 products
Image
SKU
Product
Rating
Price

Crown Automotive
  • Water Pump Stud;
  • Water Pump Stud
  • Product Attributes:
    • WARNING CA Proposition 65: No
    • Engine Make/Size:
      • Jeep 2.5l
      • Jeep 4.0l
      • Jeep 4.2l
  • Features:
    • Water Pump Stud
  • Crown Automotive is the premiere manufacturer and distributor of quality replacement parts for Jeep(R) CJ(TM), Wrangler(TM), Cherokee(TM), Grand Cherokee(TM), Liberty(TM), and Commander(TM). With over 8,000 different parts in stock for Jeep(R) vehicles from 1942 on up, Crown has the largest stock of replacement parts for Jeep(R) vehicles, including factory-discontinued parts. In fact, many of the older Jeeps are still on (and off) the road thanks to Crown parts. The Crown line consists of axle, body, brake, clutch, cooling, driveline, electrical, engine, exhaust, fuel, steering, suspension, transmission and transfer case components. Crown Automotive also offers an exclusive line of component kits and accessory products. Because we know that Jeeps are driven harder than most other vehicles, we emphasize offering only quality parts. In fact, we test parts on Jeeps before distributing them to our dealers to insure that they meet our standards for quality. Crown also supports its entire line with a 12 month/12,000 mile warranty to insure our dealers and their customers of our commitment to offering quality parts.

Additional Fitment Information:
Vehicle Sub Model
1981 - Jeep Cherokee Base

Rein
  • w/o 335D, M3
  • 8 x 32mm - Required when replacing Water Pump or Thermostat - Set of 3

Additional Fitment Information:
Vehicle
2006 - BMW 325xi

Rein
  • 8 x 32mm - Required when replacing Water Pump or Thermostat - Set of 3

Additional Fitment Information:
Vehicle Body
2009 - BMW 328i Convertible

Rein
  • w/o Turbo, Water Pump, Screw
  • 8 x 32mm - Required when replacing Water Pump or Thermostat - Set of 3

Additional Fitment Information:
Vehicle Aspiration
2010 - BMW Z4 Naturally Aspirated

Rein
  • Non Turbo, Water Pump Assy, Screw
  • 8 x 32mm - Required when replacing Water Pump or Thermostat - Set of 3

Additional Fitment Information:
Vehicle Block CC Engine CID
2008 - BMW X5 L 2996 6 Cyl 3.0L -

Genuine
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Pulley
  • M6 x 16.5mm

Additional Fitment Information:
Vehicle Engine Designation
2008 - Volkswagen Jetta CCTA

Genuine
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • with Flat Head Bolt
  • M6 X 28

Additional Fitment Information:
Vehicle Fuel Type Aspiration
2009 - Volkswagen Jetta GAS Turbocharged

VDO
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • w/o 335D, M3

Additional Fitment Information:
Vehicle Body
2007 - BMW 335i Sedan

VDO
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • w/o Turbo, Water Pump, Screw

Additional Fitment Information:
Vehicle Aspiration
2010 - BMW Z4 Naturally Aspirated

VDO
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.

Additional Fitment Information:
Vehicle Body
2007 - BMW 328i Convertible
Showing 1 - 10 of 126 products

Loading...