1987 Behr Parts


Showing 1 - 10 of 51 products
Image
SKU
Product
Rating
Price

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • For Additional Blower
  • Located on receiver drier for auxiliary cooling fan. Identified by 2 spade terminals on short pigtail with red base.

Additional Fitment Information:
Vehicle
1987 - Mercedes-Benz 300E

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • At Receiver-Drier Located on receiver drier for auxiliary cooling fan. Identified by 2 spade terminals on short pigtail with red base.

Additional Fitment Information:
Vehicle
1987 - Mercedes-Benz 420SEL

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • 90 Degree Elbow
  • 90 Degree Elbow

Additional Fitment Information:
Vehicle
1987 - Mercedes-Benz 300E

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • New with Clutch
  • Includes Clutch

Additional Fitment Information:
Vehicle Block CC Engine CID
1987 - Chevrolet P20 L - 6 Cyl 4.8L 292

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • New with Clutch

Additional Fitment Information:
Vehicle Block CC Engine CID
1987 - Pontiac Grand Prix V 3800 6 Cyl 3.8L 231

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Plastic
  • Plastic

Additional Fitment Information:
Vehicle
1987 - Mercedes-Benz 300TD

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • plastic

Additional Fitment Information:
Vehicle
1987 - Mercedes-Benz 300E

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.

Additional Fitment Information:
Vehicle
1987 - Porsche 944

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • 2 bar low pressure and 30 bar high pressure binary switch. This switch is designed to be compatible with R-12 and R134a refrigerants. Located on reciever-drier with 2 spade terminals. Used for compressor cut-out.

Additional Fitment Information:
Vehicle
1987 - Mercedes-Benz 300D

Behr
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • with Aluminum Inlet
  • Aluminum Inlet refers to the Heater Valve Inlet Tube. This core is most easily identified by the positioning of the Inlet Tube and the Heater Valve. The tube and the valve are located on the end of the core in a "stacked" position one above the other.

Additional Fitment Information:
Vehicle
1987 - BMW 325es
Showing 1 - 10 of 51 products

Loading...